Chandeliers designs APK

Chandeliers is a set of decorative lights put together on one stand, and hanging from the center of the ceiling to illuminate the whole room. They were first made by glassmakers from Bohemia in the early 16th century, with stone crystals and quartz. Maintenance lighting styles are found in medieval churches, monasteries, or in the homes of the rich at Moments, but today, it is an integral part of house lighting. There are many beautiful designs of theses-that come, and you can match them with your home interior. It is very simple to install one on your own; All you need to do is make sure you do it the right way.

Instructions
The first chandeliers are illuminated by candles in their crystal stands, and they are hung with common holders from the center of the ceiling. They light the whole room or by the reflection of the candle light on the skillful crystal cut off the stand. Today, they come in different shapes and colors, made of different materials. Mentioned below are some pointers about one hanging from the ceiling on your own:

To start with it, specify the location where you want to install it, and remove the current fixture to replace it with a new one. As it involves disconnecting the power cord, turn off the main circuit controlling the electric room.

Use the ladder to remove the old fixture canopy, and remove the cable. This connection between the old lights and the home wiring willhave a pair of twist-on-connector that can be removed by hand.

Dispose of old electrical materials, and record the old equipment to hand over to the maid. Remove all equipment involved With The Old fixtures such as screws, bar support, and loose Finns, with driver screws and a whipsaw. Finally, what should be left is an empty hole with the power cord.

Another important tip is to install the first brace support. If the chandelier is heavy, the support bracket willhave hexagonal support, with the fork attached directly to the wood ceiling together. This will, perhaps, be necessary to provide the right support. Tighten with leverage.

Drag about 6 inches or wire from the knockout hole into the new power box and fasten the cable connector with the screw driver. These connector cables should not be overtightened and should bear non-metals to avoid penetrating the cable insulation.

Once this is done, plug the power box in the safe-where you have eaten the cable. Attach it to brace with screws or tight bolts Make sure the support is full.

Now, remove the chain link and raise the new lights for the height, with the help of the maid. Remove enough chains to hang onto an Unwanted heights certainement of the ceiling, and connect the wires with which housing.
Peel about an inch of insulation from the end of the cable, and connect it to the light cord with a touch-on connector. Attach the canopy treatment completely by tucking the remaining wires into the electrical box, and slide the canopy up to tighten to the ceiling.

Add LED lights, hanging lamp shades, and other decorative equipment with care. Flip the circuit breaker, and test whether the lights work.

Thesis with simple instructions, you can easily fix it by yourself. However, make sure thatthis installation is done fully care to avoid injury or damage.